CUSTOMER SERVICE: 1-541-205-6610 (9am-4pm PT Mon-Fri)
2013 Holiday Shipping Deadlines


Free Ground Shipping
*Orders Over $100
*Oversize Fees May Apply

Blog
Read Our Blog Here!
New Stories Weekdays


  Home > RC Parts & Accessories > Helicopter Accessories >

  Carbon Fiber Blade set (1 CW + 1 CCW) compatible with the 350 QX propeller adapters
Carbon Fiber Blade set (1 CW + 1 CCW) compatible with the 350 QX propeller adapters


 
Our Price: $14.49

Stock Status:(Out of Stock)
Availability: : Currently Unavailable
Product Code: MAYCFPS
Qty:

Description
 

Carbon Fiber Blade set (1 CW + 1 CCW) compatible with the 350 QX propeller adapters with 6mm hole for an exact fit with CNC Prop adapters. Props are 8 x 4.5 Note: These props are made to our own specifications and are designed to fit snug on the CNC prop adapters with no O-rings, even though they are included in the package with the props.


Please Note: These carbon fiber propellers do NOT have directional arrows indicating the correct propeller for the specific motor. Please use caution when switching to the carbon fiber propellers and verify correct pitch before removing and replacing propellers. Installing props in the wrong configuration will cause a crash and loss of control.

These props are some of the best carbon fiber props available. They are very rigid and strong, resulting in less vibration. We have tested these props on the Blade 350QX and found that they actually improve flight performance and reduce vibration. Caution: Don't over tighten the props on the adapters or they can crack from too much pressure!


We recommend balancing these props before using them for flight. By balancing your props you will remove excess vibration from being introduced to both your quad copter electronics and your camera if you are flying with one.

We have a great Magnetic Prop Balancer here that you can use on a variety of props for planes and quad copters.

Important Info:
Each package contains two props. One counter clockwise and one clockwise. You will need two (2) of these sets to replace all 4 propellers. We have test flown these props and found them to be very high quality and reliable. Please pay attention to the prop direction and blade angles when replacing your stock props as these do not have the direction arrow printed on them.


Average Customer Review: 4 of 5 | Total Reviews: 10 Write a review.

  0 of 0 people found the following review helpful:
 
Good Choice for 350QX April 24, 2014
Reviewer: Scott Edgar from Klamath Falls, OR United States  
Ive been flying with these Carbon Fiber props for quite awhile now. They needed verly little balancing and are resonably quiet in flight . I have abused them with minor to moderate prop strikes and they are quite tough.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Light and performant February 11, 2014
Reviewer: Chris P. from Berkeley, CA  
Just a hair lighter than the 350QX stock blades.  Perform well.  Make sure to balance before using.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Super Tough with a Great Hummmm February 8, 2014
Reviewer: Chico D from Chico, CA United States  
For the money these blades are incredible.  I would of given a five star rating, but I couldn't due to the fact they aren't pre-blanaced.  My QX 350 took four hard crashes before I had to replace my first set of CF Blades, and that fourth crash was so bad nothing survived.  My Blade 350 went upside down, full speed into the ground, (my bad) and two of the four CF Blades snapped.  Once you start using flying outside SAFE MODE you need two Carbon Fiber Blade sets to survive.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Great props! fit perfectly January 27, 2014
Reviewer: Joe Songer from Springville, AL United States  
I have seen the reviews about decreased flight times. I have seen no evidence of this on my 350qx and the CF props sold here. My flight times haven't varied from stock props. Bought the bundle, installed them in half an hour and went flying. My flight time didn't increase, but they didn't decrease either. I got 13-15 minutes without my GoPro on board on a Turnegy 2200 mah lipo. They only thing I discovered, is punch out at take-off is slower, but once in the air I saw no difference. It flies a little smoother. Just my personal experience. The props are light and strong and install on cnc prop adapters without needing adapter rings.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Failure January 8, 2014
Reviewer: F.R. Pettit from Washington, UT United States  
The intent was to increase flight times.
Ran series of tests with stock props.
Results 11 to 13 minutes. 4 batteries
Installed CF props.
Ran same test series.
Results 6 to 8 minutes. Same 4 batteries.
Re-installed stock props.
Ran same test series.
Result 11 to 13 minutes. Same 4 batteries.
Conclusion:
Stock props are far superior to these CF props.


Was this review helpful to you?

View All Customer Reviews

Browse for more products in the same category as this item:

RC Parts & Accessories > Helicopter Accessories
Blade 350 QX Parts Listing > Optional Accessories