The Park 480 Brushless Outrunner motor is designed to deliver clean and quiet power for 3D park flyers weighing 20 to 30 ounces (565 to 850 grams), scale park flyers weighing 25 to 35 ounces (710 to 990 grams), or models requiring up to 275 watts of power. It’s an especially good match for E-flite's Mini Edge 3D ARF (EFL2225) and Mini Funtana 3D ARF (EFL2075), and it would provide extreme power for sport park flyers such as the Mini Ultra Stick ARF (EFL2250).

Specifically this 1020Kv option can handle more current than the 920Kv version, so it is more efficient when matched with the Thunder Power Pro-Lite cells.

• Type: Brushless outrunner
• Size: Park flyer
• Bearings or Bushings: One 4 x 9 x 4mm Bearing, and One 4 x 10 x 4mm Bearing
• Wire Gauge: 16
• Recommended Prop Range: 10x7 to 12x6
• Voltage: 7.2 to 12
• RPM/Volt (Kv): 1020
• Resistance (Ri): .06 ohms
• Idle Current (Io): 1.10A @ 8V
• Continuous Current: 22A
• Maximum Burst Current: 28A (15 sec)
• Cells: 6–10 Ni-Cd/Ni-MH or 2–3S Li-Po
• Speed Control: 25A to 40A brushless
• Weight: 87 g (3.1 oz)
• Overall Diameter: 35mm (1.40 in)
• Shaft Diameter: 4mm (.16 in)
• Overall Length: 33mm (1.30 in)

Needed to Complete:

• 25A–40A brushless ESC 2S–3S Li-Po or 6- to 10-cell Ni-MH/Ni-Cd
  
• 10x7–12x6 propeller 

Tech Notes
This motor is more ideal for the Thunder Power Pro-Lite cells (ending in PL) because it can handle more current. If using the original or Gen II cells, try the 920Kv version. Maximum operating temperature: 220 degrees Fahrenheit. Adequate cooling is required for all motor operation at maximum current levels. Maximum burst current duration is 15 seconds. Adequate time between maximum burst intervals is required.