Our RC Logger RC Eye One Xtreme Aluminum Motor Mount set is CNC machined from billet aluminum making it very strong and keeping it light. It is designed as a stock replacement and will fit the stock frame with no modifications.
The unique design of this aluminum mount securely holds the motor in place with 2 set screws. These mounts will give the confidence needed for worry free flying.
The mount also acts as a heat sink keeping your motors running cooler for longer life and better performance.
The RC Eye One Xtreme Aluminum Motor Mount set will also work with the aftermarket PFG Xtreme CarbonQuad Sport Micro Frame.
- Install original motor into motor mount. Run wires through motor mount tube and secure motor with 2 supplies screws
- Slip motor mount into frame tube and secure with 2 supplied screws
- A small drop of blue loctite can be used on screw threads
Included: 4 - RC Eye One Xtreme Aluminum Motor Mounts, 16 - M2x4mm long screws
Weight (single mount): 2.5g
When installing the motor into the mount, tighten the 2 sets screws so the motor does not spin or pull out. Not a lot of pressure will be needed for this. Do not over tighten screws. Adding a drop of loctite to the threads will ensure the screws will stay in place.
When installing the 2 screws to secure the mount to the frame, you will need to apply a little pressure to get the screws started into the frame. Once started, make sure they are straight and then tighten into the threaded hole of the aluminum mount.
When used with the PFG frame, you can cut off the tube section with a hack saw if desired.
Always check mounting screws before each flight to ensure nothing has come loose from vibrations.
- RC Eye One Xtreme original motors